Convert CONFIG_ENV_SPI_BUS et al to Kconfig
This converts the following to Kconfig:
CONFIG_ENV_SPI_BUS
CONFIG_ENV_SPI_CS
CONFIG_ENV_SPI_MAX_HZ
CONFIG_ENV_SPI_MODE
As part of this, we use Kconfig to provide the defaults now that were
done in include/spi_flash.h. We also in some cases change from using
CONFIG_ENV_SPI_FOO to CONFIG_SF_DEFAULT_FOO as those were the values in
use anyhow as ENV was not enabled.
Signed-off-by: Tom Rini <trini@konsulko.com>
diff --git a/drivers/net/pfe_eth/Kconfig b/drivers/net/pfe_eth/Kconfig
index a13b331..b2724ee 100644
--- a/drivers/net/pfe_eth/Kconfig
+++ b/drivers/net/pfe_eth/Kconfig
@@ -9,4 +9,20 @@
hex "PFE base address"
default 0x04000000
+config SYS_FSL_PFE_SPI_BUS
+ int "Value of SPI flash bus for PFE firmware"
+ default SF_DEFAULT_BUS
+
+config SYS_FSL_PFE_SPI_CS
+ int "Value of SPI flash chip select for PFE firmware"
+ default SF_DEFAULT_CS
+
+config SYS_FSL_PFE_SPI_MAX_HZ
+ int "Value of SPI flash max frequency for PFE firmware"
+ default SF_DEFAULT_SPEED
+
+config SYS_FSL_PFE_SPI_MODE
+ hex "Value of SPI flash work mode for PFE firmware"
+ default SF_DEFAULT_MODE
+
endif
diff --git a/drivers/net/pfe_eth/pfe_firmware.c b/drivers/net/pfe_eth/pfe_firmware.c
index ad5bc3c..93e5ea5 100644
--- a/drivers/net/pfe_eth/pfe_firmware.c
+++ b/drivers/net/pfe_eth/pfe_firmware.c
@@ -179,10 +179,10 @@
if (!addr)
return -ENOMEM;
- ret = spi_flash_probe_bus_cs(CONFIG_ENV_SPI_BUS,
- CONFIG_ENV_SPI_CS,
- CONFIG_ENV_SPI_MAX_HZ,
- CONFIG_ENV_SPI_MODE,
+ ret = spi_flash_probe_bus_cs(CONFIG_SYS_FSL_PFE_SPI_BUS,
+ CONFIG_SYS_FSL_PFE_SPI_CS,
+ CONFIG_SYS_FSL_PFE_SPI_MAX_HZ,
+ CONFIG_SYS_FSL_PFE_SPI_MODE,
&new);
if (ret) {
printf("SF: failed to probe spi\n");