diff --git a/README b/README
index 31e08fc..0d295a7 100644
--- a/README
+++ b/README
@@ -2597,6 +2597,10 @@
 		Enables the driver for the SPI controllers on i.MX and MXC
 		SoCs. Currently i.MX31/35/51 are supported.
 
+		CONFIG_SYS_SPI_MXC_WAIT
+		Timeout for waiting until spi transfer completed.
+		default: (CONFIG_SYS_HZ/100)     /* 10 ms */
+
 - FPGA Support: CONFIG_FPGA
 
 		Enables FPGA subsystem.
diff --git a/doc/device-tree-bindings/spi/spi-bus.txt b/doc/device-tree-bindings/spi/spi-bus.txt
index 800dafe..5c8720a 100644
--- a/doc/device-tree-bindings/spi/spi-bus.txt
+++ b/doc/device-tree-bindings/spi/spi-bus.txt
@@ -59,6 +59,8 @@
                       used for MOSI. Defaults to 1 if not present.
 - spi-rx-bus-width - (optional) The bus width(number of data wires) that
                       used for MISO. Defaults to 1 if not present.
+- spi-half-duplex  - (optional) Indicates that the SPI bus should wait for
+		      a header byte before reading data from the slave.
 
 Some SPI controllers and devices support Dual and Quad SPI transfer mode.
 It allows data in SPI system transfered in 2 wires(DUAL) or 4 wires(QUAD).
diff --git a/drivers/misc/cros_ec_spi.c b/drivers/misc/cros_ec_spi.c
index 7df709c..015333f 100644
--- a/drivers/misc/cros_ec_spi.c
+++ b/drivers/misc/cros_ec_spi.c
@@ -98,7 +98,7 @@
 	}
 
 	out = dev->dout;
-	out[0] = cmd_version;
+	out[0] = EC_CMD_VERSION0 + cmd_version;
 	out[1] = cmd;
 	out[2] = (uint8_t)dout_len;
 	memcpy(out + 3, dout, dout_len);
@@ -165,7 +165,7 @@
  */
 int cros_ec_spi_init(struct cros_ec_dev *dev, const void *blob)
 {
-	dev->spi = spi_setup_slave_fdt(blob, dev->parent_node, dev->node);
+	dev->spi = spi_setup_slave_fdt(blob, dev->node, dev->parent_node);
 	if (!dev->spi) {
 		debug("%s: Could not setup SPI slave\n", __func__);
 		return -1;
diff --git a/drivers/mtd/spi/sf_ops.c b/drivers/mtd/spi/sf_ops.c
index ef91b92..85cf22d 100644
--- a/drivers/mtd/spi/sf_ops.c
+++ b/drivers/mtd/spi/sf_ops.c
@@ -421,6 +421,7 @@
 		data += read_len;
 	}
 
+	free(cmd);
 	return ret;
 }
 
diff --git a/drivers/spi/exynos_spi.c b/drivers/spi/exynos_spi.c
index c92276f..2969184 100644
--- a/drivers/spi/exynos_spi.c
+++ b/drivers/spi/exynos_spi.c
@@ -428,10 +428,6 @@
 	clrbits_le32(&spi_slave->regs->cs_reg, SPI_SLAVE_SIG_INACT);
 	debug("Activate CS, bus %d\n", spi_slave->slave.bus);
 	spi_slave->skip_preamble = spi_slave->mode & SPI_PREAMBLE;
-
-	/* Remember time of this transaction so we can honour the bus delay */
-	if (spi_slave->bus->deactivate_delay_us)
-		spi_slave->last_transaction_us = timer_get_us();
 }
 
 /**
@@ -445,6 +441,11 @@
 	struct exynos_spi_slave *spi_slave = to_exynos_spi(slave);
 
 	setbits_le32(&spi_slave->regs->cs_reg, SPI_SLAVE_SIG_INACT);
+
+	/* Remember time of this transaction so we can honour the bus delay */
+	if (spi_slave->bus->deactivate_delay_us)
+		spi_slave->last_transaction_us = timer_get_us();
+
 	debug("Deactivate CS, bus %d\n", spi_slave->slave.bus);
 }
 
diff --git a/drivers/spi/mxc_spi.c b/drivers/spi/mxc_spi.c
index f3f029d..2d5f385 100644
--- a/drivers/spi/mxc_spi.c
+++ b/drivers/spi/mxc_spi.c
@@ -30,6 +30,10 @@
 #define reg_read readl
 #define reg_write(a, v) writel(v, a)
 
+#if !defined(CONFIG_SYS_SPI_MXC_WAIT)
+#define CONFIG_SYS_SPI_MXC_WAIT		(CONFIG_SYS_HZ/100)	/* 10 ms */
+#endif
+
 struct mxc_spi_slave {
 	struct spi_slave slave;
 	unsigned long	base;
@@ -212,6 +216,8 @@
 	int nbytes = DIV_ROUND_UP(bitlen, 8);
 	u32 data, cnt, i;
 	struct cspi_regs *regs = (struct cspi_regs *)mxcs->base;
+	u32 ts;
+	int status;
 
 	debug("%s: bitlen %d dout 0x%x din 0x%x\n",
 		__func__, bitlen, (u32)dout, (u32)din);
@@ -272,9 +278,16 @@
 	reg_write(&regs->ctrl, mxcs->ctrl_reg |
 		MXC_CSPICTRL_EN | MXC_CSPICTRL_XCH);
 
+	ts = get_timer(0);
+	status = reg_read(&regs->stat);
 	/* Wait until the TC (Transfer completed) bit is set */
-	while ((reg_read(&regs->stat) & MXC_CSPICTRL_TC) == 0)
-		;
+	while ((status & MXC_CSPICTRL_TC) == 0) {
+		if (get_timer(ts) > CONFIG_SYS_SPI_MXC_WAIT) {
+			printf("spi_xchg_single: Timeout!\n");
+			return -1;
+		}
+		status = reg_read(&regs->stat);
+	}
 
 	/* Transfer completed, clear any pending request */
 	reg_write(&regs->stat, MXC_CSPICTRL_TC | MXC_CSPICTRL_RXOVF);
diff --git a/drivers/spi/spi.c b/drivers/spi/spi.c
index 7ddea9b..7d81fbd 100644
--- a/drivers/spi/spi.c
+++ b/drivers/spi/spi.c
@@ -53,6 +53,8 @@
 		mode |= SPI_CPHA;
 	if (fdtdec_get_bool(blob, node, "spi-cs-high"))
 		mode |= SPI_CS_HIGH;
+	if (fdtdec_get_bool(blob, node, "spi-half-duplex"))
+		mode |= SPI_PREAMBLE;
 	return spi_setup_slave(busnum, cs, max_hz, mode);
 }
 #endif