board: ti: dra7xx: Select MCAN instead of DCAN on DRA76 EVM
MCAN can be accessed via DCAN1 or DCAN2. Determining which DCAN instance
to use if any at all is done through
CTRL_CORE_CONTROL_SPARE_RW.SEL_ALT_MCAN. Since general pinmuxing is
handled in U-boot. Handle this additional pinmuxing requirement in U-boot
to ensure that MCAN is used by default via the DCAN1 pins.
Reviewed-by: Lokesh Vutla <lokeshvutla@ti.com>
Signed-off-by: Vignesh R <vigneshr@ti.com>
[fcooper@ti.com: Update commit message and use DCAN1 not DCAN2 for MCAN]
Signed-off-by: Franklin S Cooper Jr <fcooper@ti.com>
Signed-off-by: Lokesh Vutla <lokeshvutla@ti.com>
Signed-off-by: Faiz Abbas <faiz_abbas@ti.com>
diff --git a/arch/arm/include/asm/arch-omap5/mux_dra7xx.h b/arch/arm/include/asm/arch-omap5/mux_dra7xx.h
index 55f49c7..dc2eb60 100644
--- a/arch/arm/include/asm/arch-omap5/mux_dra7xx.h
+++ b/arch/arm/include/asm/arch-omap5/mux_dra7xx.h
@@ -351,4 +351,7 @@
#define NMIN_DSP 0x460
#define RSTOUTN 0x464
+#define MCAN_SEL_ALT_MASK 0x6000
+#define MCAN_SEL 0x2000
+
#endif /* _MUX_DRA7XX_H_ */
diff --git a/board/ti/dra7xx/evm.c b/board/ti/dra7xx/evm.c
index 6bcfa48..ddcbe31 100644
--- a/board/ti/dra7xx/evm.c
+++ b/board/ti/dra7xx/evm.c
@@ -823,6 +823,11 @@
do_set_mux32((*ctrl)->control_padconf_core_base,
delta_pads, delta_npads);
+ if (is_dra76x())
+ /* Set mux for MCAN instead of DCAN1 */
+ clrsetbits_le32((*ctrl)->control_core_control_spare_rw,
+ MCAN_SEL_ALT_MASK, MCAN_SEL);
+
/* Setup IOdelay configuration */
ret = do_set_iodelay((*ctrl)->iodelay_config_base, iodelay, niodelays);
err: