spi: ti_qspi: Add delay before xfer for am43xx
Without this delay, write/read is failing.
Looks like, the WIP always remain set and hence a timeout
occurs leading to the error.
Without this patch, device does not get probed also.
Here is the log.
U-Boot#
U-Boot#
U-Boot#
U-Boot# sf probe 0
SF: Unsupported flash IDs: manuf ff, jedec ffff, ext_jedec ffff
Failed to initialize SPI flash at 0:0
U-Boot# sf probe 0
While with this patch, log is
U-Boot# sf probe 0
SF: Detected MX25L51235F with page size 256 Bytes, erase size 64 KiB, total 64 MiB, mapped at 30000000
U-Boot# sf erase 0 0x80000
SF: 524288 bytes @ 0x0 Erased: OK
U-Boot# mw 81000000 0xdededede 0x40000
U-Boot# sf write 81000000 0 0x40000
SF: 262144 bytes @ 0x0 Written: OK
U-Boot# sf read 82000000 0 0x40000
SF: 262144 bytes @ 0x0 Read: OK
U-Boot# md 0x82000000
Signed-off-by: Sourav Poddar <sourav.poddar@ti.com>
Reviewed-by: Jagannadha Sutradharudu Teki <jaganna@xilinx.com>
diff --git a/drivers/spi/ti_qspi.c b/drivers/spi/ti_qspi.c
index 5666250..dfa5d0c 100644
--- a/drivers/spi/ti_qspi.c
+++ b/drivers/spi/ti_qspi.c
@@ -285,6 +285,13 @@
qslave->cmd |= QSPI_3_PIN;
qslave->cmd |= 0xfff;
+/* FIXME: This delay is required for successfull
+ * completion of read/write/erase. Once its root
+ * caused, it will be remove from the driver.
+ */
+#ifdef CONFIG_AM43XX
+ udelay(100);
+#endif
while (words--) {
if (txp) {
debug("tx cmd %08x dc %08x data %02x\n",