serial: msm-geni: Use upstream Linux bindings
The name "se" is used in upstream Linux device trees and has been for
ages, long before this U-Boot-ism was introduced. Same goes for the
existing compatible. Get rid of that.
[vzapolskiy: removed a ready change in the driver]
Signed-off-by: Konrad Dybcio <konrad.dybcio@linaro.org>
Signed-off-by: Vladimir Zapolskiy <vladimir.zapolskiy@linaro.org>
diff --git a/arch/arm/dts/sdm845.dtsi b/arch/arm/dts/sdm845.dtsi
index 607af27..92bdc82 100644
--- a/arch/arm/dts/sdm845.dtsi
+++ b/arch/arm/dts/sdm845.dtsi
@@ -52,10 +52,10 @@
};
debug_uart: serial@a84000 {
- compatible = "qcom,msm-geni-uart";
+ compatible = "qcom,geni-debug-uart";
reg = <0xa84000 0x4000>;
reg-names = "se_phys";
- clock-names = "se-clk";
+ clock-names = "se";
clocks = <&gcc GCC_QUPV3_WRAP1_S1_CLK>;
pinctrl-names = "default";
pinctrl-0 = <&qup_uart9>;
diff --git a/doc/device-tree-bindings/serial/msm-geni-serial.txt b/doc/device-tree-bindings/serial/msm-geni-serial.txt
index 9eadc25..eaa39c9 100644
--- a/doc/device-tree-bindings/serial/msm-geni-serial.txt
+++ b/doc/device-tree-bindings/serial/msm-geni-serial.txt
@@ -1,6 +1,6 @@
Qualcomm GENI UART
Required properties:
-- compatible: must be "qcom,msm-geni-uart"
+- compatible: must be "qcom,geni-debug-uart"
- reg: start address and size of the registers
- clock: interface clock (must accept baudrate as a frequency)
diff --git a/drivers/serial/serial_msm_geni.c b/drivers/serial/serial_msm_geni.c
index 3a200f4..29fae81 100644
--- a/drivers/serial/serial_msm_geni.c
+++ b/drivers/serial/serial_msm_geni.c
@@ -547,7 +547,9 @@
}
static const struct udevice_id msm_serial_ids[] = {
- {.compatible = "qcom,msm-geni-uart"}, {}};
+ { .compatible = "qcom,geni-debug-uart" },
+ { }
+};
U_BOOT_DRIVER(serial_msm_geni) = {
.name = "serial_msm_geni",