spi: Add support SH Quad SPI driver
This patch adds a driver for Renesas SoC's Quad SPI bus.
This supports with 8 bits per transfer to use with SPI flash.
Signed-off-by: Kouei Abe <kouei.abe.cp@renesas.com>
Signed-off-by: Nobuhiro Iwamatsu <nobuhiro.iwamatsu.yj@renesas.com>
Signed-off-by: Jagannadha Sutradharudu Teki <jaganna@xilinx.com>
diff --git a/doc/SPI/README.sh_qspi_test b/doc/SPI/README.sh_qspi_test
new file mode 100644
index 0000000..8a33fec
--- /dev/null
+++ b/doc/SPI/README.sh_qspi_test
@@ -0,0 +1,38 @@
+-------------------------------------------------
+ Simple steps used to test the SH-QSPI at U-Boot
+-------------------------------------------------
+
+#0, Currently, SH-QSPI is used by lager board (Renesas ARM SoC R8A7790)
+ and koelsch board (Renesas ARM SoC R8A7791). These boot from SPI ROM
+ basically. Thus, U-Boot start, SH-QSPI will is operating normally.
+
+#1, build U-Boot and load u-boot.bin
+
+ => tftpboot 40000000 u-boot.bin
+ sh_eth Waiting for PHY auto negotiation to complete.. done
+ sh_eth: 100Base/Half
+ Using sh_eth device
+ TFTP from server 192.168.169.1; our IP address is 192.168.169.79
+ Filename 'u-boot.bin'.
+ Load address: 0x40000000
+ Loading: ############
+ 2.5 MiB/s
+ done
+ Bytes transferred = 175364 (2ad04 hex)
+
+#2, Commands to erase/write u-boot to flash device
+
+ Note: This method is description of the lager board. If you want to use the
+ other boards, please change the value according to each environment.
+
+ => sf probe 0
+ SF: Detected S25FL512S_256K with page size 512 Bytes, erase size 64 KiB, total 64 MiB
+ => sf erase 80000 40000
+ SF: 262144 bytes @ 0x80000 Erased: OK
+ => sf write 40000000 80000 175364
+ SF: 1528676 bytes @ 0x80000 Written: OK
+ =>
+
+#3, Push reset button.
+
+ If you're written correctly and driver works properly, U-Boot starts.