ARM: OMAP5: Enable ABB configuration for MM voltage domain
Since we setup the voltage and frequency for the MM domain, we *must*
setup the ABB configuration needed for the domain as well. If we do not
do this, kernel configuring just the frequency using the default boot
loader configured voltage can fail on many corner lot units.
Reported-by: Richard Woodruff <r-woodruff2@ti.com>
Signed-off-by: Nishanth Menon <nm@ti.com>
diff --git a/arch/arm/cpu/armv7/omap5/hw_data.c b/arch/arm/cpu/armv7/omap5/hw_data.c
index a4b31e4..dfb1df6 100644
--- a/arch/arm/cpu/armv7/omap5/hw_data.c
+++ b/arch/arm/cpu/armv7/omap5/hw_data.c
@@ -361,6 +361,7 @@
.mm.value = VDD_MM_ES2,
.mm.addr = SMPS_REG_ADDR_45_IVA,
.mm.pmic = &palmas,
+ .mm.abb_tx_done_mask = OMAP_ABB_MM_TXDONE_MASK,
};
struct vcores_data dra752_volts = {