board/BuR/common: try to setup cpsw mac-address from the devicetree
since we have a dtb blob programmed on the board we try to setup the cpsw
interface with the programmed mac.
If this method fails, we fall back to the device-fuses.
Signed-off-by: Hannes Petermaier <oe5hpm@oevsv.at>
diff --git a/board/BuR/common/common.c b/board/BuR/common/common.c
index 7d0e05c..18e1520b 100644
--- a/board/BuR/common/common.c
+++ b/board/BuR/common/common.c
@@ -591,9 +591,9 @@
int board_eth_init(bd_t *bis)
{
int rv = 0;
- uint8_t mac_addr[6];
+ char mac_addr[6];
+ const char *mac = 0;
uint32_t mac_hi, mac_lo;
-
/* try reading mac address from efuse */
mac_lo = readl(&cdev->macid0l);
mac_hi = readl(&cdev->macid0h);
@@ -607,14 +607,19 @@
#if (defined(CONFIG_DRIVER_TI_CPSW) && !defined(CONFIG_SPL_BUILD)) || \
(defined(CONFIG_SPL_ETH_SUPPORT) && defined(CONFIG_SPL_BUILD))
if (!getenv("ethaddr")) {
- printf("<ethaddr> not set. Validating first E-fuse MAC ... ");
+ #if !defined(CONFIG_SPL_BUILD) && defined(CONFIG_USE_FDT)
+ printf("<ethaddr> not set. trying DTB ... ");
+ mac = dtbmacaddr(0);
+ #endif
+ if (!mac) {
+ printf("<ethaddr> not set. validating E-fuse MAC ... ");
+ if (is_valid_ether_addr((const u8 *)mac_addr))
+ mac = (const char *)mac_addr;
+ }
- if (is_valid_ether_addr(mac_addr)) {
- printf("using: %02X:%02X:%02X:%02X:%02X:%02X.\n",
- mac_addr[0], mac_addr[1], mac_addr[2],
- mac_addr[3], mac_addr[4], mac_addr[5]
- );
- eth_setenv_enetaddr("ethaddr", mac_addr);
+ if (mac) {
+ printf("using: %pM on ", mac);
+ eth_setenv_enetaddr("ethaddr", (const u8 *)mac);
}
}
writel(MII_MODE_ENABLE, &cdev->miisel);