sifive: fu540: Add Booting from SPI
Add booting from SPI for SiFive Unleashed board.
Signed-off-by: Jagan Teki <jagan@amarulasolutions.com>
Reviewed-by: Bin Meng <bin.meng@windriver.com>
Tested-by: Bin Meng <bin.meng@windriver.com>
diff --git a/doc/board/sifive/fu540.rst b/doc/board/sifive/fu540.rst
index 739eefa..1ce9ab1 100644
--- a/doc/board/sifive/fu540.rst
+++ b/doc/board/sifive/fu540.rst
@@ -533,3 +533,44 @@
type: 0fc63daf-8483-4772-8e79-3d69d8477de4
type: linux
guid: 9faa81b6-39b1-4418-af5e-89c48f29c20d
+
+Booting from SPI
+----------------
+
+Use Building steps from "Booting from MMC using U-Boot SPL" section.
+
+Partition the SPI in Linux via mtdblock. (Require to boot the board in
+SD boot mode by enabling MTD block in Linux)
+
+Use prebuilt image from here [1], which support to partition the SPI flash.
+
+.. code-block:: none
+
+ # sgdisk --clear \
+ > --set-alignment=2 \
+ > --new=1:40:2087 --change-name=1:loader1 --typecode=1:5B193300-FC78-40CD-8002-E86C45580B47 \
+ > --new=2:2088:10279 --change-name=2:loader2 --typecode=2:2E54B353-1271-4842-806F-E436D6AF6985 \
+ > --new=3:10536:65494 --change-name=3:rootfs --typecode=3:0FC63DAF-8483-4772-8E79-3D69D8477DE4 \
+ > /dev/mtdblock0
+
+Program the SPI (Require to boot the board in SD boot mode)
+
+Execute below steps on U-Boot proper,
+
+.. code-block:: none
+
+ tftpboot $kernel_addr_r u-boot-spl.bin
+ sf erase 0x5000 $filesize
+ sf write $kernel_addr_r 0x5000 $filesize
+
+ tftpboot $kernel_addr_r u-boot.itb
+ sf erase 0x105000 $filesize
+ sf write $kernel_addr_r 0x105000 $filesize
+
+Power off the board
+
+Change DIP switches MSEL[3:0] are set to 0110
+
+Power up the board.
+
+[1] https://github.com/amarula/bsp-sifive