pinctrl: tegra20: adjust pin type detection
Pin detection on t20 depends on node name. With recent changes
in node naming, let's remove '_' to be safe about both '_' or
'-' use.
Signed-off-by: Svyatoslav Ryhel <clamor95@gmail.com>
diff --git a/drivers/pinctrl/tegra/pinctrl-tegra20.c b/drivers/pinctrl/tegra/pinctrl-tegra20.c
index d5171b8..d59b3ec 100644
--- a/drivers/pinctrl/tegra/pinctrl-tegra20.c
+++ b/drivers/pinctrl/tegra/pinctrl-tegra20.c
@@ -97,9 +97,9 @@
* then actual pins setup (with node name prefix
* conf_*) and then drive setup.
*/
- if (!strncmp(child->name, "conf_", 5))
+ if (!strncmp(child->name, "conf", 4))
tegra_pinctrl_set_pin(child);
- else if (!strncmp(child->name, "drive_", 6))
+ else if (!strncmp(child->name, "drive", 5))
debug("%s: drive configuration is not supported\n", __func__);
else
tegra_pinctrl_set_func(child);