rename CFG_ macros to CONFIG_SYS
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
diff --git a/include/configs/actux2.h b/include/configs/actux2.h
index a3f5a4a..7e6e8f2 100644
--- a/include/configs/actux2.h
+++ b/include/configs/actux2.h
@@ -32,7 +32,7 @@
#define CONFIG_DISPLAY_CPUINFO 1
#define CONFIG_DISPLAY_BOARDINFO 1
-#define CFG_IXP425_CONSOLE IXP425_UART2
+#define CONFIG_SYS_IXP425_CONSOLE IXP425_UART2
#define CONFIG_BAUDRATE 115200
#define CONFIG_BOOTDELAY 5
#define CONFIG_ZERO_BOOTDELAY_CHECK /* check for keypress on bootdelay==0 */
@@ -43,9 +43,9 @@
#undef CONFIG_USE_IRQ
/* Size of malloc() pool */
-#define CFG_MALLOC_LEN (CONFIG_ENV_SIZE + 128*1024)
+#define CONFIG_SYS_MALLOC_LEN (CONFIG_ENV_SIZE + 128*1024)
/* size in bytes reserved for initial data */
-#define CFG_GBL_DATA_SIZE 128
+#define CONFIG_SYS_GBL_DATA_SIZE 128
/* allow to overwrite serial and ethaddr */
#define CONFIG_ENV_OVERWRITE
@@ -71,30 +71,30 @@
#endif
/* Miscellaneous configurable options */
-#define CFG_LONGHELP
-#define CFG_PROMPT "=> "
+#define CONFIG_SYS_LONGHELP
+#define CONFIG_SYS_PROMPT "=> "
/* Console I/O Buffer Size */
-#define CFG_CBSIZE 256
+#define CONFIG_SYS_CBSIZE 256
/* Print Buffer Size */
-#define CFG_PBSIZE (CFG_CBSIZE+sizeof(CFG_PROMPT)+16)
+#define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE+sizeof(CONFIG_SYS_PROMPT)+16)
/* max number of command args */
-#define CFG_MAXARGS 16
+#define CONFIG_SYS_MAXARGS 16
/* Boot Argument Buffer Size */
-#define CFG_BARGSIZE CFG_CBSIZE
+#define CONFIG_SYS_BARGSIZE CONFIG_SYS_CBSIZE
-#define CFG_MEMTEST_START 0x00400000
-#define CFG_MEMTEST_END 0x00800000
+#define CONFIG_SYS_MEMTEST_START 0x00400000
+#define CONFIG_SYS_MEMTEST_END 0x00800000
/* everything, incl board info, in Hz */
-#undef CFG_CLKS_IN_HZ
+#undef CONFIG_SYS_CLKS_IN_HZ
/* spec says 66.666 MHz, but it appears to be 33 */
-#define CFG_HZ 3333333
+#define CONFIG_SYS_HZ 3333333
/* default load address */
-#define CFG_LOAD_ADDR 0x00010000
+#define CONFIG_SYS_LOAD_ADDR 0x00010000
/* valid baudrates */
-#define CFG_BAUDRATE_TABLE { 9600, 19200, 38400, 57600, \
+#define CONFIG_SYS_BAUDRATE_TABLE { 9600, 19200, 38400, 57600, \
115200, 230400 }
#define CONFIG_SERIAL_RTS_ACTIVE 1
@@ -109,39 +109,39 @@
#endif
/* Expansion bus settings */
-#define CFG_EXP_CS0 0xbd113042
+#define CONFIG_SYS_EXP_CS0 0xbd113042
/* SDRAM settings */
#define CONFIG_NR_DRAM_BANKS 1
#define PHYS_SDRAM_1 0x00000000
-#define CFG_DRAM_BASE 0x00000000
+#define CONFIG_SYS_DRAM_BASE 0x00000000
/* 16MB SDRAM */
-#define CFG_SDR_CONFIG 0x3A
+#define CONFIG_SYS_SDR_CONFIG 0x3A
#define PHYS_SDRAM_1_SIZE 0x01000000
-#define CFG_SDRAM_REFRESH_CNT 0x81a
-#define CFG_SDR_MODE_CONFIG 0x1
-#define CFG_DRAM_SIZE 0x01000000
+#define CONFIG_SYS_SDRAM_REFRESH_CNT 0x81a
+#define CONFIG_SYS_SDR_MODE_CONFIG 0x1
+#define CONFIG_SYS_DRAM_SIZE 0x01000000
/* FLASH organization */
-#define CFG_MAX_FLASH_BANKS 1
+#define CONFIG_SYS_MAX_FLASH_BANKS 1
/* max number of sectors on one chip */
-#define CFG_MAX_FLASH_SECT 140
+#define CONFIG_SYS_MAX_FLASH_SECT 140
#define PHYS_FLASH_1 0x50000000
-#define CFG_FLASH_BANKS_LIST { PHYS_FLASH_1 }
+#define CONFIG_SYS_FLASH_BANKS_LIST { PHYS_FLASH_1 }
-#define CFG_FLASH_BASE PHYS_FLASH_1
-#define CFG_MONITOR_BASE PHYS_FLASH_1
-#define CFG_MONITOR_LEN (256 << 10)
+#define CONFIG_SYS_FLASH_BASE PHYS_FLASH_1
+#define CONFIG_SYS_MONITOR_BASE PHYS_FLASH_1
+#define CONFIG_SYS_MONITOR_LEN (256 << 10)
/* Use common CFI driver */
-#define CFG_FLASH_CFI
+#define CONFIG_SYS_FLASH_CFI
#define CONFIG_FLASH_CFI_DRIVER
/* no byte writes on IXP4xx */
-#define CFG_FLASH_CFI_WIDTH FLASH_CFI_16BIT
+#define CONFIG_SYS_FLASH_CFI_WIDTH FLASH_CFI_16BIT
/* print 'E' for empty sector on flinfo */
-#define CFG_FLASH_EMPTY_INFO
+#define CONFIG_SYS_FLASH_EMPTY_INFO
/* Ethernet */
@@ -155,7 +155,7 @@
/* MII PHY management */
#define CONFIG_MII 1
/* Number of ethernet rx buffers & descriptors */
-#define CFG_RX_ETH_BUFFER 16
+#define CONFIG_SYS_RX_ETH_BUFFER 16
#define CONFIG_RESET_PHY_R 1
/* ethernet switch connected to MII port */
#define CONFIG_MII_ETHSWITCH 1
@@ -173,7 +173,7 @@
#define CONFIG_BOOTP_HOSTNAME
/* Cache Configuration */
-#define CFG_CACHELINE_SIZE 32
+#define CONFIG_SYS_CACHELINE_SIZE 32
/*
* environment organization:
@@ -182,7 +182,7 @@
#define CONFIG_ENV_IS_IN_FLASH 1
#define CONFIG_ENV_SIZE 0x2000
#define CONFIG_ENV_ADDR (PHYS_FLASH_1 + 0x4000)
-#define CFG_USE_PPCENV 1
+#define CONFIG_SYS_USE_PPCENV 1
#define CONFIG_EXTRA_ENV_SETTINGS \
"mtd=IXP4XX-Flash.0:256k(uboot),64k(ucode),1152k(linux),-(root)\0" \