rename CFG_ macros to CONFIG_SYS

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
diff --git a/board/tqc/tqm5200/tqm5200.c b/board/tqc/tqm5200/tqm5200.c
index 5152331..faa2e02 100644
--- a/board/tqc/tqm5200/tqm5200.c
+++ b/board/tqc/tqm5200/tqm5200.c
@@ -54,7 +54,7 @@
 void ps2mult_early_init(void);
 #endif
 
-#ifndef CFG_RAMBOOT
+#ifndef CONFIG_SYS_RAMBOOT
 static void sdram_start (int hi_addr)
 {
 	long hi_addr_bit = hi_addr ? 0x01000000 : 0;
@@ -101,7 +101,7 @@
 
 /*
  * ATTENTION: Although partially referenced initdram does NOT make real use
- *	      use of CFG_SDRAM_BASE. The code does not work if CFG_SDRAM_BASE
+ *	      use of CONFIG_SYS_SDRAM_BASE. The code does not work if CONFIG_SYS_SDRAM_BASE
  *	      is something else than 0x00000000.
  */
 
@@ -111,7 +111,7 @@
 	ulong dramsize2 = 0;
 	uint svr, pvr;
 
-#ifndef CFG_RAMBOOT
+#ifndef CONFIG_SYS_RAMBOOT
 	ulong test1, test2;
 
 	/* setup SDRAM chip selects */
@@ -132,9 +132,9 @@
 
 	/* find RAM size using SDRAM CS0 only */
 	sdram_start(0);
-	test1 = get_ram_size((long *)CFG_SDRAM_BASE, 0x20000000);
+	test1 = get_ram_size((long *)CONFIG_SYS_SDRAM_BASE, 0x20000000);
 	sdram_start(1);
-	test2 = get_ram_size((long *)CFG_SDRAM_BASE, 0x20000000);
+	test2 = get_ram_size((long *)CONFIG_SYS_SDRAM_BASE, 0x20000000);
 	if (test1 > test2) {
 		sdram_start(0);
 		dramsize = test1;
@@ -161,10 +161,10 @@
 	/* find RAM size using SDRAM CS1 only */
 	if (!dramsize)
 		sdram_start(0);
-	test2 = test1 = get_ram_size((long *)(CFG_SDRAM_BASE + dramsize), 0x20000000);
+	test2 = test1 = get_ram_size((long *)(CONFIG_SYS_SDRAM_BASE + dramsize), 0x20000000);
 	if (!dramsize) {
 		sdram_start(1);
-		test2 = get_ram_size((long *)(CFG_SDRAM_BASE + dramsize), 0x20000000);
+		test2 = get_ram_size((long *)(CONFIG_SYS_SDRAM_BASE + dramsize), 0x20000000);
 	}
 	if (test1 > test2) {
 		sdram_start(0);
@@ -186,7 +186,7 @@
 		*(vu_long *)MPC5XXX_SDRAM_CS1CFG = dramsize; /* disabled */
 	}
 
-#else /* CFG_RAMBOOT */
+#else /* CONFIG_SYS_RAMBOOT */
 
 	/* retrieve size of memory connected to SDRAM CS0 */
 	dramsize = *(vu_long *)MPC5XXX_SDRAM_CS0CFG & 0xFF;
@@ -203,7 +203,7 @@
 	} else {
 		dramsize2 = 0;
 	}
-#endif /* CFG_RAMBOOT */
+#endif /* CONFIG_SYS_RAMBOOT */
 
 	/*
 	 * On MPC5200B we need to set the special configuration delay in the
@@ -406,7 +406,7 @@
 	ps2mult_early_init();
 #endif /* CONFIG_PS2MULT */
 
-#if defined(CONFIG_USB_OHCI_NEW) && defined(CFG_USB_OHCI_CPU_INIT)
+#if defined(CONFIG_USB_OHCI_NEW) && defined(CONFIG_SYS_USB_OHCI_CPU_INIT)
 	/* Low level USB init, required for proper kernel operation */
 	usb_cpu_init();
 #endif
@@ -464,34 +464,34 @@
 	 */
 
 	/* save original SRAM content  */
-	save = *(volatile u16 *)CFG_CS2_START;
+	save = *(volatile u16 *)CONFIG_SYS_CS2_START;
 	restore = 1;
 
 	/* write test pattern to SRAM */
-	*(volatile u16 *)CFG_CS2_START = 0xA5A5;
+	*(volatile u16 *)CONFIG_SYS_CS2_START = 0xA5A5;
 	__asm__ volatile ("sync");
 	/*
 	 * Put a different pattern on the data lines: otherwise they may float
 	 * long enough to read back what we wrote.
 	 */
-	tmp = *(volatile u16 *)CFG_FLASH_BASE;
+	tmp = *(volatile u16 *)CONFIG_SYS_FLASH_BASE;
 	if (tmp == 0xA5A5)
 		puts ("!! possible error in SRAM detection\n");
 
-	if (*(volatile u16 *)CFG_CS2_START != 0xA5A5) {
+	if (*(volatile u16 *)CONFIG_SYS_CS2_START != 0xA5A5) {
 		/* no SRAM at all, disable cs */
 		*(vu_long *)MPC5XXX_ADDECR &= ~(1 << 18);
 		*(vu_long *)MPC5XXX_CS2_START = 0x0000FFFF;
 		*(vu_long *)MPC5XXX_CS2_STOP = 0x0000FFFF;
 		restore = 0;
 		__asm__ volatile ("sync");
-	} else if (*(volatile u16 *)(CFG_CS2_START + (1<<19)) == 0xA5A5) {
+	} else if (*(volatile u16 *)(CONFIG_SYS_CS2_START + (1<<19)) == 0xA5A5) {
 		/* make sure that we access a mirrored address */
-		*(volatile u16 *)CFG_CS2_START = 0x1111;
+		*(volatile u16 *)CONFIG_SYS_CS2_START = 0x1111;
 		__asm__ volatile ("sync");
-		if (*(volatile u16 *)(CFG_CS2_START + (1<<19)) == 0x1111) {
+		if (*(volatile u16 *)(CONFIG_SYS_CS2_START + (1<<19)) == 0x1111) {
 			/* SRAM size = 512 kByte */
-			*(vu_long *)MPC5XXX_CS2_STOP = STOP_REG(CFG_CS2_START,
+			*(vu_long *)MPC5XXX_CS2_STOP = STOP_REG(CONFIG_SYS_CS2_START,
 								0x80000);
 			__asm__ volatile ("sync");
 			puts ("SRAM:  512 kB\n");
@@ -503,7 +503,7 @@
 	}
 	/* restore origianl SRAM content  */
 	if (restore) {
-		*(volatile u16 *)CFG_CS2_START = save;
+		*(volatile u16 *)CONFIG_SYS_CS2_START = save;
 		__asm__ volatile ("sync");
 	}
 
@@ -513,21 +513,21 @@
 	 */
 
 	/* save origianl FB content  */
-	save = *(volatile u16 *)CFG_CS1_START;
+	save = *(volatile u16 *)CONFIG_SYS_CS1_START;
 	restore = 1;
 
 	/* write test pattern to FB memory */
-	*(volatile u16 *)CFG_CS1_START = 0xA5A5;
+	*(volatile u16 *)CONFIG_SYS_CS1_START = 0xA5A5;
 	__asm__ volatile ("sync");
 	/*
 	 * Put a different pattern on the data lines: otherwise they may float
 	 * long enough to read back what we wrote.
 	 */
-	tmp = *(volatile u16 *)CFG_FLASH_BASE;
+	tmp = *(volatile u16 *)CONFIG_SYS_FLASH_BASE;
 	if (tmp == 0xA5A5)
 		puts ("!! possible error in grafic controller detection\n");
 
-	if (*(volatile u16 *)CFG_CS1_START != 0xA5A5) {
+	if (*(volatile u16 *)CONFIG_SYS_CS1_START != 0xA5A5) {
 		/* no grafic controller at all, disable cs */
 		*(vu_long *)MPC5XXX_ADDECR &= ~(1 << 17);
 		*(vu_long *)MPC5XXX_CS1_START = 0x0000FFFF;
@@ -539,7 +539,7 @@
 	}
 	/* restore origianl FB content  */
 	if (restore) {
-		*(volatile u16 *)CFG_CS1_START = save;
+		*(volatile u16 *)CONFIG_SYS_CS1_START = save;
 		__asm__ volatile ("sync");
 	}
 
@@ -679,21 +679,21 @@
 	 */
 
 	/* save origianl FB content  */
-	save = *(volatile u16 *)CFG_CS1_START;
+	save = *(volatile u16 *)CONFIG_SYS_CS1_START;
 	restore = 1;
 
 	/* write test pattern to FB memory */
-	*(volatile u16 *)CFG_CS1_START = 0xA5A5;
+	*(volatile u16 *)CONFIG_SYS_CS1_START = 0xA5A5;
 	__asm__ volatile ("sync");
 	/*
 	 * Put a different pattern on the data lines: otherwise they may float
 	 * long enough to read back what we wrote.
 	 */
-	tmp = *(volatile u16 *)CFG_FLASH_BASE;
+	tmp = *(volatile u16 *)CONFIG_SYS_FLASH_BASE;
 	if (tmp == 0xA5A5)
 		puts ("!! possible error in grafic controller detection\n");
 
-	if (*(volatile u16 *)CFG_CS1_START != 0xA5A5) {
+	if (*(volatile u16 *)CONFIG_SYS_CS1_START != 0xA5A5) {
 		/* no grafic controller found */
 		restore = 0;
 		ret = 0;
@@ -702,7 +702,7 @@
 	}
 
 	if (restore) {
-		*(volatile u16 *)CFG_CS1_START = save;
+		*(volatile u16 *)CONFIG_SYS_CS1_START = save;
 		__asm__ volatile ("sync");
 	}
 	return ret;