mmc: renesas-sdhi: Send stop when MMC tuning command fails
When tuning command (CMD21) fails with command error, call
mmc_send_stop_transmission() to send stop command (CMD12).
Reviewed-by: Takeshi Kihara <takeshi.kihara.df@renesas.com>
Reviewed-by: Marek Vasut <marek.vasut+renesas@mailbox.org>
Signed-off-by: Hai Pham <hai.pham.ud@renesas.com>
Signed-off-by: Marek Vasut <marek.vasut+renesas@mailbox.org>
[Marek: Add dev_dbg() message in case tuning abort fails
Move tuning opcode check from mmc_abort_tuning()]
Reviewed-by: Peng Fan <peng.fan@nxp.com>
diff --git a/drivers/mmc/renesas-sdhi.c b/drivers/mmc/renesas-sdhi.c
index 280d96d..8e716f7 100644
--- a/drivers/mmc/renesas-sdhi.c
+++ b/drivers/mmc/renesas-sdhi.c
@@ -611,6 +611,17 @@
priv->smpcmp |= BIT(i);
mdelay(1);
+
+ /*
+ * eMMC specification specifies that CMD12 can be used to stop a tuning
+ * command, but SD specification does not, so do nothing unless it is
+ * eMMC.
+ */
+ if (ret && (opcode == MMC_CMD_SEND_TUNING_BLOCK_HS200)) {
+ ret = mmc_send_stop_transmission(mmc, false);
+ if (ret < 0)
+ dev_dbg(dev, "Tuning abort fail (%d)\n", ret);
+ }
}
ret = renesas_sdhi_select_tuning(priv, taps);