ti: k3: drivers: sec_proxy: Switch error messages
The logic is correct here, but the error messages are
reversed, switch them.
Signed-off-by: Andrew F. Davis <afd@ti.com>
Acked-by: Nishanth Menon <nm@ti.com>
diff --git a/plat/ti/k3/common/drivers/sec_proxy/sec_proxy.c b/plat/ti/k3/common/drivers/sec_proxy/sec_proxy.c
index 5dd54d4..2a013ed 100644
--- a/plat/ti/k3/common/drivers/sec_proxy/sec_proxy.c
+++ b/plat/ti/k3/common/drivers/sec_proxy/sec_proxy.c
@@ -139,10 +139,10 @@
if ((mmio_read_32(spt->scfg + SCFG_THREAD_CTRL) & SCFG_THREAD_CTRL_DIR_MASK)
!= (dir << SCFG_THREAD_CTRL_DIR_SHIFT)) {
if (dir)
- ERROR("Trying to receive data on tx Thread %d\n",
+ ERROR("Trying to send data on RX Thread %d\n",
spt->id);
else
- ERROR("Trying to send data on rx Thread %d\n",
+ ERROR("Trying to receive data on TX Thread %d\n",
spt->id);
return -EINVAL;
}