stm32mp1: Add PMIC support
If a PMIC companion chip is present on board, it has to be configured
for regulators supplies.
This check is done with board DT configuration.
Signed-off-by: Yann Gautier <yann.gautier@st.com>
Signed-off-by: Pascal Paillet <p.paillet@st.com>
diff --git a/include/drivers/st/stpmu1.h b/include/drivers/st/stpmu1.h
new file mode 100644
index 0000000..1b93ab2
--- /dev/null
+++ b/include/drivers/st/stpmu1.h
@@ -0,0 +1,141 @@
+/*
+ * Copyright (c) 2016-2018, STMicroelectronics - All Rights Reserved
+ *
+ * SPDX-License-Identifier: BSD-3-Clause
+ */
+
+
+#ifndef __STPMU1_H__
+#define __STPMU1_H__
+
+#include <stm32_i2c.h>
+#include <utils_def.h>
+
+#define TURN_ON_REG 0x1U
+#define TURN_OFF_REG 0x2U
+#define ICC_LDO_TURN_OFF_REG 0x3U
+#define ICC_BUCK_TURN_OFF_REG 0x4U
+#define RESET_STATUS_REG 0x5U
+#define VERSION_STATUS_REG 0x6U
+#define MAIN_CONTROL_REG 0x10U
+#define PADS_PULL_REG 0x11U
+#define BUCK_PULL_DOWN_REG 0x12U
+#define LDO14_PULL_DOWN_REG 0x13U
+#define LDO56_PULL_DOWN_REG 0x14U
+#define VIN_CONTROL_REG 0x15U
+#define PONKEY_TIMER_REG 0x16U
+#define MASK_RANK_BUCK_REG 0x17U
+#define MASK_RESET_BUCK_REG 0x18U
+#define MASK_RANK_LDO_REG 0x19U
+#define MASK_RESET_LDO_REG 0x1AU
+#define WATCHDOG_CONTROL_REG 0x1BU
+#define WATCHDOG_TIMER_REG 0x1CU
+#define BUCK_ICC_TURNOFF_REG 0x1DU
+#define LDO_ICC_TURNOFF_REG 0x1EU
+#define BUCK_APM_CONTROL_REG 0x1FU
+#define BUCK1_CONTROL_REG 0x20U
+#define BUCK2_CONTROL_REG 0x21U
+#define BUCK3_CONTROL_REG 0x22U
+#define BUCK4_CONTROL_REG 0x23U
+#define VREF_DDR_CONTROL_REG 0x24U
+#define LDO1_CONTROL_REG 0x25U
+#define LDO2_CONTROL_REG 0x26U
+#define LDO3_CONTROL_REG 0x27U
+#define LDO4_CONTROL_REG 0x28U
+#define LDO5_CONTROL_REG 0x29U
+#define LDO6_CONTROL_REG 0x2AU
+#define BUCK1_PWRCTRL_REG 0x30U
+#define BUCK2_PWRCTRL_REG 0x31U
+#define BUCK3_PWRCTRL_REG 0x32U
+#define BUCK4_PWRCTRL_REG 0x33U
+#define VREF_DDR_PWRCTRL_REG 0x34U
+#define LDO1_PWRCTRL_REG 0x35U
+#define LDO2_PWRCTRL_REG 0x36U
+#define LDO3_PWRCTRL_REG 0x37U
+#define LDO4_PWRCTRL_REG 0x38U
+#define LDO5_PWRCTRL_REG 0x39U
+#define LDO6_PWRCTRL_REG 0x3AU
+#define FREQUENCY_SPREADING_REG 0x3BU
+#define USB_CONTROL_REG 0x40U
+#define ITLATCH1_REG 0x50U
+#define ITLATCH2_REG 0x51U
+#define ITLATCH3_REG 0x52U
+#define ITLATCH4_REG 0x53U
+#define ITSETLATCH1_REG 0x60U
+#define ITSETLATCH2_REG 0x61U
+#define ITSETLATCH3_REG 0x62U
+#define ITSETLATCH4_REG 0x63U
+#define ITCLEARLATCH1_REG 0x70U
+#define ITCLEARLATCH2_REG 0x71U
+#define ITCLEARLATCH3_REG 0x72U
+#define ITCLEARLATCH4_REG 0x73U
+#define ITMASK1_REG 0x80U
+#define ITMASK2_REG 0x81U
+#define ITMASK3_REG 0x82U
+#define ITMASK4_REG 0x83U
+#define ITSETMASK1_REG 0x90U
+#define ITSETMASK2_REG 0x91U
+#define ITSETMASK3_REG 0x92U
+#define ITSETMASK4_REG 0x93U
+#define ITCLEARMASK1_REG 0xA0U
+#define ITCLEARMASK2_REG 0xA1U
+#define ITCLEARMASK3_REG 0xA2U
+#define ITCLEARMASK4_REG 0xA3U
+#define ITSOURCE1_REG 0xB0U
+#define ITSOURCE2_REG 0xB1U
+#define ITSOURCE3_REG 0xB2U
+#define ITSOURCE4_REG 0xB3U
+#define LDO_VOLTAGE_MASK 0x7CU
+#define BUCK_VOLTAGE_MASK 0xFCU
+#define LDO_BUCK_VOLTAGE_SHIFT 2
+#define LDO_ENABLE_MASK 0x01U
+#define BUCK_ENABLE_MASK 0x01U
+#define BUCK_HPLP_ENABLE_MASK 0x02U
+#define LDO_HPLP_ENABLE_MASK 0x02U
+#define LDO_BUCK_HPLP_SHIFT 1
+#define LDO_BUCK_RANK_MASK 0x01U
+#define LDO_BUCK_RESET_MASK 0x01U
+#define LDO_BUCK_PULL_DOWN_MASK 0x03U
+
+/* Main PMIC Control Register (MAIN_CONTROL_REG) */
+#define ICC_EVENT_ENABLED BIT(4)
+#define PWRCTRL_POLARITY_HIGH BIT(3)
+#define PWRCTRL_PIN_VALID BIT(2)
+#define RESTART_REQUEST_ENABLED BIT(1)
+#define SOFTWARE_SWITCH_OFF_ENABLED BIT(0)
+
+/* Main PMIC PADS Control Register (PADS_PULL_REG) */
+#define WAKEUP_DETECTOR_DISABLED BIT(4)
+#define PWRCTRL_PD_ACTIVE BIT(3)
+#define PWRCTRL_PU_ACTIVE BIT(2)
+#define WAKEUP_PD_ACTIVE BIT(1)
+#define PONKEY_PU_ACTIVE BIT(0)
+
+/* Main PMIC VINLOW Control Register (VIN_CONTROL_REGC DMSC) */
+#define SWIN_DETECTOR_ENABLED BIT(7)
+#define SWOUT_DETECTOR_ENABLED BIT(6)
+#define VINLOW_HYST_MASK 0x3
+#define VINLOW_HYST_SHIFT 4
+#define VINLOW_THRESHOLD_MASK 0x7
+#define VINLOW_THRESHOLD_SHIFT 1
+#define VINLOW_ENABLED 0x01
+#define VINLOW_CTRL_REG_MASK 0xFF
+
+/* USB Control Register */
+#define BOOST_OVP_DISABLED BIT(7)
+#define VBUS_OTG_DETECTION_DISABLED BIT(6)
+#define OCP_LIMIT_HIGH BIT(3)
+#define SWIN_SWOUT_ENABLED BIT(2)
+#define USBSW_OTG_SWITCH_ENABLED BIT(1)
+
+int stpmu1_switch_off(void);
+int stpmu1_register_read(uint8_t register_id, uint8_t *value);
+int stpmu1_register_write(uint8_t register_id, uint8_t value);
+int stpmu1_register_update(uint8_t register_id, uint8_t value, uint8_t mask);
+int stpmu1_regulator_enable(const char *name);
+int stpmu1_regulator_disable(const char *name);
+uint8_t stpmu1_is_regulator_enabled(const char *name);
+int stpmu1_regulator_voltage_set(const char *name, uint16_t millivolts);
+void stpmu1_bind_i2c(struct i2c_handle_s *i2c_handle, uint16_t i2c_addr);
+
+#endif /* __STPMU1_H__ */