ti: k3: drivers: ti_sci: Add processor status wait API
This TI-SCI API can be used wait for a set of processor status flags to
be set or cleared. The flags are processor type specific. This command
will not return ACK until the specified status is met. NACK will be
returned after the timeout elapses or on error.
Signed-off-by: Andrew F. Davis <afd@ti.com>
Acked-by: Nishanth Menon <nm@ti.com>
diff --git a/plat/ti/k3/common/drivers/ti_sci/ti_sci.c b/plat/ti/k3/common/drivers/ti_sci/ti_sci.c
index b211bdf..f6d71a0 100644
--- a/plat/ti/k3/common/drivers/ti_sci/ti_sci.c
+++ b/plat/ti/k3/common/drivers/ti_sci/ti_sci.c
@@ -1459,6 +1459,87 @@
}
/**
+ * ti_sci_proc_wait_boot_status() - Wait for a processor boot status
+ *
+ * @proc_id: Processor ID this request is for
+ * @num_wait_iterations Total number of iterations we will check before
+ * we will timeout and give up
+ * @num_match_iterations How many iterations should we have continued
+ * status to account for status bits glitching.
+ * This is to make sure that match occurs for
+ * consecutive checks. This implies that the
+ * worst case should consider that the stable
+ * time should at the worst be num_wait_iterations
+ * num_match_iterations to prevent timeout.
+ * @delay_per_iteration_us Specifies how long to wait (in micro seconds)
+ * between each status checks. This is the minimum
+ * duration, and overhead of register reads and
+ * checks are on top of this and can vary based on
+ * varied conditions.
+ * @delay_before_iterations_us Specifies how long to wait (in micro seconds)
+ * before the very first check in the first
+ * iteration of status check loop. This is the
+ * minimum duration, and overhead of register
+ * reads and checks are.
+ * @status_flags_1_set_all_wait If non-zero, Specifies that all bits of the
+ * status matching this field requested MUST be 1.
+ * @status_flags_1_set_any_wait If non-zero, Specifies that at least one of the
+ * bits matching this field requested MUST be 1.
+ * @status_flags_1_clr_all_wait If non-zero, Specifies that all bits of the
+ * status matching this field requested MUST be 0.
+ * @status_flags_1_clr_any_wait If non-zero, Specifies that at least one of the
+ * bits matching this field requested MUST be 0.
+ *
+ * Return: 0 if all goes well, else appropriate error message
+ */
+int ti_sci_proc_wait_boot_status(uint8_t proc_id, uint8_t num_wait_iterations,
+ uint8_t num_match_iterations,
+ uint8_t delay_per_iteration_us,
+ uint8_t delay_before_iterations_us,
+ uint32_t status_flags_1_set_all_wait,
+ uint32_t status_flags_1_set_any_wait,
+ uint32_t status_flags_1_clr_all_wait,
+ uint32_t status_flags_1_clr_any_wait)
+{
+ struct ti_sci_msg_req_wait_proc_boot_status req;
+ struct ti_sci_msg_hdr resp;
+
+ struct ti_sci_xfer xfer;
+ int ret;
+
+ ret = ti_sci_setup_one_xfer(TISCI_MSG_WAIT_PROC_BOOT_STATUS,
+ TI_SCI_FLAG_REQ_ACK_ON_PROCESSED,
+ &req, sizeof(req),
+ &resp, sizeof(resp),
+ &xfer);
+ if (ret) {
+ ERROR("Message alloc failed (%d)\n", ret);
+ return ret;
+ }
+
+ req.processor_id = proc_id;
+ req.num_wait_iterations = num_wait_iterations;
+ req.num_match_iterations = num_match_iterations;
+ req.delay_per_iteration_us = delay_per_iteration_us;
+ req.delay_before_iterations_us = delay_before_iterations_us;
+ req.status_flags_1_set_all_wait = status_flags_1_set_all_wait;
+ req.status_flags_1_set_any_wait = status_flags_1_set_any_wait;
+ req.status_flags_1_clr_all_wait = status_flags_1_clr_all_wait;
+ req.status_flags_1_clr_any_wait = status_flags_1_clr_any_wait;
+
+ ret = ti_sci_do_xfer(&xfer);
+ if (ret) {
+ ERROR("Transfer send failed (%d)\n", ret);
+ return ret;
+ }
+
+ if (!ti_sci_is_response_ack(&resp))
+ return -ENODEV;
+
+ return 0;
+}
+
+/**
* ti_sci_init() - Basic initialization
*
* Return: 0 if all goes well, else appropriate error message
diff --git a/plat/ti/k3/common/drivers/ti_sci/ti_sci.h b/plat/ti/k3/common/drivers/ti_sci/ti_sci.h
index 1176b00..91f8645 100644
--- a/plat/ti/k3/common/drivers/ti_sci/ti_sci.h
+++ b/plat/ti/k3/common/drivers/ti_sci/ti_sci.h
@@ -179,6 +179,7 @@
* and then set the processor configuration flags.
* @cert_addr: Memory address at which payload image certificate is located.
* - ti_sci_proc_get_boot_status - Command to get the processor boot status
+ * - ti_sci_proc_wait_boot_status - Command to wait for a processor boot status
*
* NOTE: for all these functions, the following are generic in nature:
* @proc_id: Processor ID
@@ -197,6 +198,14 @@
uint32_t *cfg_flags,
uint32_t *ctrl_flags,
uint32_t *sts_flags);
+int ti_sci_proc_wait_boot_status(uint8_t proc_id, uint8_t num_wait_iterations,
+ uint8_t num_match_iterations,
+ uint8_t delay_per_iteration_us,
+ uint8_t delay_before_iterations_us,
+ uint32_t status_flags_1_set_all_wait,
+ uint32_t status_flags_1_set_any_wait,
+ uint32_t status_flags_1_clr_all_wait,
+ uint32_t status_flags_1_clr_any_wait);
/**
* ti_sci_init() - Basic initialization
diff --git a/plat/ti/k3/common/drivers/ti_sci/ti_sci_protocol.h b/plat/ti/k3/common/drivers/ti_sci/ti_sci_protocol.h
index c6d76d7..a921e51 100644
--- a/plat/ti/k3/common/drivers/ti_sci/ti_sci_protocol.h
+++ b/plat/ti/k3/common/drivers/ti_sci/ti_sci_protocol.h
@@ -46,6 +46,7 @@
#define TISCI_MSG_SET_PROC_BOOT_CTRL 0xc101
#define TISCI_MSG_PROC_AUTH_BOOT_IMIAGE 0xc120
#define TISCI_MSG_GET_PROC_BOOT_STATUS 0xc400
+#define TISCI_MSG_WAIT_PROC_BOOT_STATUS 0xc401
/**
* struct ti_sci_msg_hdr - Generic Message Header for All messages and responses
@@ -647,4 +648,52 @@
uint32_t status_flags;
} __packed;
+/**
+ * struct ti_sci_msg_req_wait_proc_boot_status - Wait for a processor boot status
+ * @hdr: Generic Header
+ * @processor_id: ID of processor
+ * @num_wait_iterations Total number of iterations we will check before
+ * we will timeout and give up
+ * @num_match_iterations How many iterations should we have continued
+ * status to account for status bits glitching.
+ * This is to make sure that match occurs for
+ * consecutive checks. This implies that the
+ * worst case should consider that the stable
+ * time should at the worst be num_wait_iterations
+ * num_match_iterations to prevent timeout.
+ * @delay_per_iteration_us Specifies how long to wait (in micro seconds)
+ * between each status checks. This is the minimum
+ * duration, and overhead of register reads and
+ * checks are on top of this and can vary based on
+ * varied conditions.
+ * @delay_before_iterations_us Specifies how long to wait (in micro seconds)
+ * before the very first check in the first
+ * iteration of status check loop. This is the
+ * minimum duration, and overhead of register
+ * reads and checks are.
+ * @status_flags_1_set_all_wait If non-zero, Specifies that all bits of the
+ * status matching this field requested MUST be 1.
+ * @status_flags_1_set_any_wait If non-zero, Specifies that at least one of the
+ * bits matching this field requested MUST be 1.
+ * @status_flags_1_clr_all_wait If non-zero, Specifies that all bits of the
+ * status matching this field requested MUST be 0.
+ * @status_flags_1_clr_any_wait If non-zero, Specifies that at least one of the
+ * bits matching this field requested MUST be 0.
+ *
+ * Request type is TISCI_MSG_WAIT_PROC_BOOT_STATUS, response is appropriate
+ * message, or NACK in case of inability to satisfy request.
+ */
+struct ti_sci_msg_req_wait_proc_boot_status {
+ struct ti_sci_msg_hdr hdr;
+ uint8_t processor_id;
+ uint8_t num_wait_iterations;
+ uint8_t num_match_iterations;
+ uint8_t delay_per_iteration_us;
+ uint8_t delay_before_iterations_us;
+ uint32_t status_flags_1_set_all_wait;
+ uint32_t status_flags_1_set_any_wait;
+ uint32_t status_flags_1_clr_all_wait;
+ uint32_t status_flags_1_clr_any_wait;
+} __packed;
+
#endif /* TI_SCI_PROTOCOL_H */