Tegra: console clock settings for real/FPGA platforms
This patch sets up the clock for the UART console, for real Silicon
and FPGA platforms. FPGA platforms run the UART clock source at
13MHz, whereas the clock cource runs at 408MHz for real silicon.
Change-Id: Ibfd99df032ec473f29e636e597cfc95a0f580598
Signed-off-by: Harvey Hsieh <hhsieh@nvidia.com>
Signed-off-by: Varun Wadekar <vwadekar@nvidia.com>
diff --git a/plat/nvidia/tegra/common/tegra_bl31_setup.c b/plat/nvidia/tegra/common/tegra_bl31_setup.c
index b496650..9aacaa0 100644
--- a/plat/nvidia/tegra/common/tegra_bl31_setup.c
+++ b/plat/nvidia/tegra/common/tegra_bl31_setup.c
@@ -27,6 +27,7 @@
#include <memctrl.h>
#include <tegra_def.h>
+#include <tegra_platform.h>
#include <tegra_private.h>
/* length of Trusty's input parameters (in bytes) */
@@ -122,6 +123,7 @@
plat_params_from_bl2_t *plat_params = (plat_params_from_bl2_t *)arg1;
image_info_t bl32_img_info = { {0} };
uint64_t tzdram_start, tzdram_end, bl32_start, bl32_end;
+ uint32_t console_clock;
/*
* For RESET_TO_BL31 systems, BL31 is the first bootloader to run so
@@ -165,6 +167,15 @@
panic();
/*
+ * Reference clock used by the FPGAs is a lot slower.
+ */
+ if (tegra_platform_is_fpga() == 1U) {
+ console_clock = TEGRA_BOOT_UART_CLK_13_MHZ;
+ } else {
+ console_clock = TEGRA_BOOT_UART_CLK_408_MHZ;
+ }
+
+ /*
* Get the base address of the UART controller to be used for the
* console
*/
@@ -174,8 +185,8 @@
/*
* Configure the UART port to be used as the console
*/
- console_init(tegra_console_base, TEGRA_BOOT_UART_CLK_IN_HZ,
- TEGRA_CONSOLE_BAUDRATE);
+ console_init(tegra_console_base, console_clock,
+ TEGRA_CONSOLE_BAUDRATE);
}
/*