ti: k3: common: sec_proxy: Fill non-message data fields with 0x0
Sec proxy data buffer is 60 bytes with the last of the registers
indicating transmission completion. This however poses a bit
of a challenge.
The backing memory for sec_proxy is regular memory, and all sec proxy
does is to trigger a burst of all 60 bytes of data over to the target
thread backing ring accelerator. It doesn't do a memory scrub when
it moves data out in the burst. When we transmit multiple messages,
remnants of previous message is also transmitted which results in
some random data being set in TISCI fields of messages that have been
expanded forward.
The entire concept of backward compatibility hinges on the fact that
the unused message fields remain 0x0 allowing for 0x0 value to be
specially considered when backward compatibility of message extension
is done.
So, instead of just writing the completion register, we continue
to fill the message buffer up with 0x0 (note: for partial message
involving completion, we already do this).
This allows us to scale and introduce ABI changes back into TF-A only
as needed.
Signed-off-by: Nishanth Menon <nm@ti.com>
Change-Id: Ie22cb2a319f4aa80aef23ffc7e059207e5d4c640
diff --git a/plat/ti/k3/common/drivers/sec_proxy/sec_proxy.c b/plat/ti/k3/common/drivers/sec_proxy/sec_proxy.c
index ee1eecf..cbe5fda 100644
--- a/plat/ti/k3/common/drivers/sec_proxy/sec_proxy.c
+++ b/plat/ti/k3/common/drivers/sec_proxy/sec_proxy.c
@@ -261,9 +261,14 @@
/*
* 'data_reg' indicates next register to write. If we did not already
* write on tx complete reg(last reg), we must do so for transmit
+ * In addition, we also need to make sure all intermediate data
+ * registers(if any required), are reset to 0 for TISCI backward
+ * compatibility to be maintained.
*/
- if (data_reg <= spm.desc.data_end_offset)
- mmio_write_32(spt->data + spm.desc.data_end_offset, 0);
+ while (data_reg <= spm.desc.data_end_offset) {
+ mmio_write_32(spt->data + data_reg, 0);
+ data_reg += sizeof(uint32_t);
+ }
VERBOSE("Message successfully sent on thread %s\n", spt->name);